Shake well before use.

Get ready with 3 pieces of a brand-new, lint-free microfiber towel.

When first applying AUTOTRIZ Top Coat on a substrate, it is recommended to condition the surface of the applicator block with 7-8 drops to prevent skipping or dry spots.

Do not work on a large area at a time. It is recommended to do a 1.5 ft. x 1.5 ft. at a time.

Apply AUTOTRIZ Top Coat using normal pressure on the applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements to ensure that product is carried through consistently.

Use the first towel to immediately level the product.

Go immediately over with a second microfiber towel with a polishing motion until the surface is free from residue.

Follow by the third towel (the “insurance towel”) and go over the surface one extra time just to make sure you haven’t missed any streaks or excess residue.

When the whole car is applied, allow the curing of the coating to begin. Wait approximately 60 minutes before delivery of the car to customers. Curing times depend on temperature and humidity.

INSPECTION LIGHTING SYSTEM

Lighting is of utmost importance during the application of a coating to paint. Spot Light like Scangrip is a good lighting system to inspect paint defects during polishing but in fact, it is NOT RECOMMENDED to use to check the residue of coating left on the paint. The suitable lighting system is Diffused Light.